The Provider assumes no responsibility for the accuracy of 3D models made with the software, the drawings and other outputs generated from them, and quotes. The generated documents are for informational purposes only.

The Service does not perform any structural or load-bearing (statics) calculation and does not verify that a model or drawing is structurally sound. The software carries out no strength, load, or safety check: the User may enter any parameters, including physically or structurally impossible ones (for example, 1×1 cm rafters over a 10-metre span), and the Service will still generate models and drawings from them without any warning. The output therefore never constitutes a statement, guarantee, or certification that the model, the drawing, the cross-sections, or the dimensions are structurally adequate or safe to build.

It is the User's sole and exclusive responsibility to verify the correctness of all cross-sections, spans, dimensions, and structural requirements, and to involve a qualified structural engineer, before using any output for actual construction or for quoting to their clients. The Provider is not liable for damages arising from possible software errors in the beta version, or from models or drawings that are structurally inadequate or otherwise unfit for construction. This limitation does not affect liability that cannot be excluded under applicable law (e.g., for damage caused intentionally or by gross negligence, or for injury to life or health).

Imprint

Service provider details

Contact

Hosting provider